Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 12 – Troubleshooting Page 12-5 CFP83 Series Neither Battery is Charging with the Engine Running NOTE: If one or both batteries do not charge with the engine stopped, troubleshoot the customer supplied battery charging system. NOTE: If only one battery is maintaining charge, go to Only One Battery is Charging with the Engine Running. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Battery cables or connections are loose, broken, or corroded (excessive resistance). Check the battery cables and connections. Refer to Battery Cables and Connections (013-009) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02.

Ensure that all connections are free of corrosion and that no cables are broken. Battery condition is poor. Load-test the battery. If the battery charge is low, charge the battery. If battery fails the second load test, replace the battery. Refer to Batteries (013-007) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Alternator rotor is not turning. Test the alternator mechanically. Refer to Alternator Checks and Testing in Section 7. If the alternator shaft does not spin freely because of a bad bearing, replace the alternator. Refer to Alternator Removal/Installation in Section 7.

If the alternator does not turn because of a bad drive belt, replace the drive belt. Refer to Belt Removal/Installation in Section 7. If the alternator does not charge because of poor drive belt tension, replace the automatic tensioner. Refer to Automatic Belt Tensioner Removal/Installation in Section 7. If the alternator pulley is loose on the shaft, tighten the pulley. Refer to Alternator Pulley (013-006) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02.