Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 12-6 Section 12 – Troubleshooting CFP83 Series Neither Battery is Charging with the Engine Running (Cont) Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Battery Isolator input has faulted. Test continuity from the alternator to the battery isolator input. Refer to Drawing 10423 Sheet 2 in Section 13. Repair any open circuit. Test continuity through the battery isolator. If an internal open circuit is detected, replace the battery isolator. Refer to Battery Isolator Removal/Installation in Section 7. Alternator excitation is lost. Test the alternator electrically. Refer to Alternator Checks and Testing in Section 7. If required, replace the replaceable diode.

Refer to Drawing 10423 Sheet 1 in Section 13. If required, locate and repair the open circuit or short to ground in the alternator excitation wiring. Alternator connection to ground is poor. Inspect the alternator mounting hardware for a proper electrical connection to the battery. Remove any paint and debris from the ground connection. Check mounting bracket bolts for proper torque. Alternator internal voltage regulator is malfunctioning. Test the alternator electrically. Refer to Alternator Checks and Testing in Section 7. If required, replace the alternator. Refer to Alternator Removal/Installation in Section 7. Battery temperature is above specification.

Position the batteries away from heat sources. Contact an Authorized Cummins Repair Facility.