Section 12 – Troubleshooting Page 12-7 CFP83 Series Only One Battery is Charging with the Engine Running NOTE: If one or both batteries do not charge with the engine stopped, troubleshoot the customer supplied battery charging system. NOTE: If neither battery is maintaining charge, go to Neither Battery is Charging with the Engine Running. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Battery has failed. Test battery condition. Refer to Battery Testing in Section 7. If the battery has failed, replace the failed battery units. Refer to Battery Removal/Installation in Section 7. Battery cables or connections are loose, broken, or corroded (excessive resistance).
Check the battery cables and connections. Ensure that all connections are free of corrosion and that no cables are broken. Battery isolator has failed. Remove the battery isolator. Refer to Battery Isolator Removal/Installation in Section 7. Test the internal diodes for open circuit or short to ground. Refer to the Schematic, Electrical Wiring, 10423 Sheet 2 in Section 13. If required, obtain a replacement battery isolator. Install the battery isolator. Refer to Battery Isolator Removal/Installation in Section 7. Voltmeter is providing false indication. Go to Voltage Indications Differ in this section. Contact an Authorized Cummins Repair Facility.