Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 12-18 Section 12 – Troubleshooting CFP83 Series Raw Water Drain Steaming NOTE: The raw water drain from the Coolant Heat Exchanger may steam if raw water flow is inadequate when the engine is running. It may also steam shortly after the engine is stopped. If coolant is leaking into the raw water drain piping, the steaming may last for some time while the engine cools. Antifreeze may also be observed in the raw water drain. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Raw water flow did not start when the engine started. Check engine coolant temperature. Go to Coolant Temperature Above Normal in this section.

Engine coolant is leaking into the raw water piping in the coolant heat exchanger. When practical, remove the coolant heat exchanger and perform the pressure test. Refer to Coolant Heat Exchanger Removal/Installation in Section 7. If pressure is not maintained, replace the heat exchanger. Contact an Authorized Cummins Repair Facility.