Section 12 – Troubleshooting Page 12-37 CFP83 Series Engine Cranks Slowly But Does Not Start NOTE: Typical engine cranking speed is 120 RPM. Engine cranking speed can be checked with a hand-held tachometer, stroboscope, or electronic service tool. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction The batteries are cold. Ensure that the batteries are protected from extreme temperatures. The battery cables or connections are loose, broken, or corroded creating excessive resistance. Check the battery cables and connections. Ensure that connections are clean and tight. The battery is not properly charged or has failed. Recharge the battery.
If the battery does not take the charge, replace it. Lubricating oil level is too high. Check the oil level. Refer to Check Engine Oil Level in Section 7. Drain any excess oil. Lubricating oil is the wrong grade or type. Check the grade and type of oil. Refer to Lubricating Oil Recommendations and Specifications in Section 10. If the wrong type or grade of oil is present, drain and replace it. Refer to Change Lubricating Oil and Filters in Section 7. Engine temperature is too low. Troubleshoot as per Coolant Temperature Below Normal (Engine Off) in this section. Starting motor is malfunctioning. Replace the starting motor. Refer to Starter Motor Assembly Removal/Installation in Section 7.
Contact a Cummins Authorized Repair Facility.