Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 12-36 Section 12 – Troubleshooting CFP83 Series Engine Cranks Normally But Will Not Start (No Exhaust Smoke) (Cont) Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Camshaft timing is not correct (after engine rebuild or repair). Check the gear train timing alignment. Refer to Camshaft (001-008) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003- 02. Fuel injectors are plugged. Replace the fuel injectors. Refer to Fuel Injectors Removal/Installation in Section 7. Throttle linkage misadjusted or damaged. Adjust or repair the linkage. Refer to instructions in Section 7. Starting motor rotation is not correct. Check the direction of crankshaft rotation.

Refer to instructions in Section 7. Replace the starting motor if necessary. Refer to Starter Motor Assembly Removal/Installation in Section 7. Starting motor is not turning the engine. Replace the starting motor if necessary. Refer to Starter Motor Assembly Removal/Installation in Section 7. Contact an Authorized Cummins Repair Facility.