Section 12 – Troubleshooting Page 12-47 CFP83 Series Engine Noise Excessive - Mechanical Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Lubricating oil is thin or diluted. Check the oil level. Refer to Check Lubricating Oil Level in Section 7. If the oil level is above the high mark, go to Oil Level Rises in this section. Otherwise, ensure that the correct type and grade of lubricating oil is being used. Refer to the Lubricating Oil Recommendations and Specifications in Section 10. Lubricating oil pressure is below specification. NOTE: Oil pressure should range between 69 and 345 kPa [10 to 50 PSI] with the engine running. Check the oil pressure on the local control panel.
If the pressure is low, refer to the Lubricating Oil Pressure Low symptom tree in this section. Vibration damper is damaged. Inspect the vibration damper. Refer to Inspect Vibration Damper in Section 5. If the vibration damper is damaged, refer to a Cummins Authorized Repair Facility. Engine mounts are worn or damaged. Inspect the engine mounts. If the engine mounts are worn or damaged, refer to a Cummins Authorized Repair Facility. Coolant temperature is above specification. Check the coolant temperature indication on the local control panel. If the high coolant temperature light is illuminated, refer to the Coolant Temperature Above Normal symptom tree in this section.