Page 12-48 Section 12 – Troubleshooting CFP83 Series Engine Noise Excessive – Mechanical (Cont) Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Drive belt is squeaking due to insufficient tension or high loading. Check the automatic belt tensioner. If required, replace the tensioner. Refer to Automatic Belt Tensioner Removal/Installation in Section 7. Intake air flow is restricted. Check the air intake system for restriction. Refer to Check Air Cleaner Service Indicator in Section 7. Replace the air filter if required. Exhaust air flow is restricted. Check the exhaust air piping for restriction. Remove any restriction. Intake air or exhaust leaks.
Refer to the Excessive Black Exhaust Smoke symptom tree in this section. Turbocharger noise. Turbocharger fluttering noises can be heard during deceleration or quick throttle closing. This noise is normal. Air leakage between the turbocharger and head. Tighten the clamp between turbocharger and head. Repair leaks between turbocharger and head. Valve lash excessive. Adjust valves. Make sure the push rods are not bent or rocker levers not severely worn. Refer to Push Rods or Tubes (004-014) and Overhead Set (003- 004) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02.