Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 12 – Troubleshooting Page 12-89 CFP83 Series Lubricating Oil Pressure High Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction The engine is cold. Allow the engine to warm to operating temperature. If the engine will not reach operating temperature, refer to the Coolant Temperature Below Normal (Engine Running) symptom tree in this section. Lubricating oil viscosity is not correct. Drain the oil and replace the oil filter. Refer to Change Lubricating Oil and Filters in Section 7. Use the correct oil. Refer to Lubricating Oil Recommendations and Specifications in Section 10. Lubricating oil filter is not correct. Replace the oil filter.

Refer to Change Lubricating Oil and Filters in Section 7. Use the correct oil filter. Refer to Lubricating Oil Recommendations and Specifications in Section 10. The pressure regulator valve is struck open. Check and replace valve. Refer to Cylinder Head (002-004) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. The lubricating oil pump installation not correct. Verify that the correct lubricating oil pump and o-rings are installed. Refer to Lubricating Oil Pump (007-031) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02.