Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Section 12 – Troubleshooting Page 12-91 CFP83 Series Lubricating Oil Pressure is Low NOTE: Low oil pressure is normally indicated by a low pressure reading on the pressure gauge and by the Low Oil Pressure Light on the engine control panel. If both low pressure indications are present, check for an actual low oil pressure. If only one indication is present, check first to see if the indication is incorrect. Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Lubricating oil level is low. Check and replenish lubricating oil. Refer to Check Lubricating Oil Level in Section 7. Cylinder head core and expansion plugs leaking or misassembled. Check cylinder head.

Refer to Cylinder Head (002- 004) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Lubricating oil is diluted. Refer to the Lubricating Oil Contaminated symptom tree in this section. Lubricating oil filter is plugged. Replace the oil and filter. Refer to Change Lubricating Oil and Filters in Section 7. Use the correct oil filter. Refer to Lubricating Oil Recommendations and Specifications in Section 10. Pressure gauge is malfunctioning. Check for electrical faults for the pressure gauge wiring. Refer to Drawing 10423 Sheet 1 in Section 13. Correct any electrical faults. Ensure that power and grounding are connected.

Ensure that the field wire to the sender is not open or shorted to ground. Correct any electrical faults. If required, replace the pressure sender. Refer to Oil Pressure Sender Removal/ Installation in Section 7. If required, replace the pressure gauge. Refer to Oil Pressure Gauge Removal/ Installation in Section 7.