Cummins — Cummins CFP83 Series Fire Pump Drive Engines Operation & Maintenance Manual

Page 12-92 Section 12 – Troubleshooting CFP83 Series Lubricating Oil Pressure is Low (Cont) Drawing No. 9777, Section 12, Rev. 02-07 Cause Correction Oil pressure switch fails to open the contacts on running pressure. The Low Oil Pressure Light remains illuminated yet the oil pressure gauge indicates normal pressure when the engine is running. Check for a short circuit in the wiring to the pressure switch or in the wiring to the remote Fire Pump Controller. Refer to Drawing 10423 Sheet 1 in Section 13. Correct any electrical faults. If required, replace the oil pressure switch. Refer to Oil Pressure Switch Removal/ Installation in Section 7. Lubricating oil filter is not correct.

Replace the oil filter. Refer to Change Lubricating Oil and Filters in Section 7. Use the correct oil filter. Refer to Lubricating Oil Recommendations and Specifications in Section 10. Pressure regulator valve is struck open. Check and replace valve. Refer to Lubricating Oil Pressure Regulator (Main Rifle) (007-029) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Lubricating oil cooler is plugged. Check the oil cooler. Refer to Lubricating Oil Cooler (007-003) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Lubricating oil cooler was replaced with shipping plugs left in cooler. Check and remove shipping plugs.

Refer to Lubricating Oil Cooler (007-003) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02. Lubricating oil pump is malfunctioning. Inspect the lubricating oil pump. Refer to Lubricating Oil Pump (007-031) in Troubleshooting and Repair Manual C Series Engines, Bulletin Number 3666003-02.