Section 3 – Installation and Operation Page 3-25 CFP83 Series Check Engine to Pump Alignment Drawing No. 9777, Section 3, Rev. 02-07 Ensure engine position is centered on Frame side to side within +-1/32”, by measuring outside of frame side to engine support leg mounting pad. (Compare two front engine supports and Two back engine supports). Align engine centerline to pump centerline within +-1/32”. The pump centerline to the engine crank centerline (in vertical plane) is to be ½” +0, -1/4” offset. NOTE: The slip joint must rest in the middle third of its travel when installed. SIDE VIEW Auxiliary Drive shaft mounting flanges must be parallel within 1.5 degrees. 90° 90° TOP VIEW