Page 3-38 Section 3 – Installation and Operation CFP83 Series Rated Speed Setpoint Adjustment (CFP83-F10, F20, F30) (Cont) To increase the rated speed, turn the bolt on the right side of the throttle bracket clockwise The adjustment of the bolt will pivot the throttle bracket counter-clockwise and will allow more fuel through the pump to speed up the engine. Loosen the lock nut and turn bolt clockwise to allow for more RPM speed. When rated speed is correct, tighten lock nut against stop. 8708-cfp83 Rated speed adjustment To decrease the speed, turn the bolt counter-clockwise on the right side of the throttle bracket.
The adjustment of the bolt will pivot the throttle bracket clockwise and will allow less fuel to flow through the pump to slow down the engine. When rated speed is correct, tighten the locking nuts against the stops. The threaded bolt on the left side of the bracket is for maximum speed and may also need to be adjusted if maximum speed cannot be reached. The same adjustment sequence can be performed for maximum speed adjustment. Stop the engine. Start the engine. Observe that the engine starts and accelerates to the rated speed setpoint. Stop the engine. Repeat the above adjustment until the desired speed is attained. Drawing No. 9777, Section 3, Rev. 02-07