Section 3 – Installation and Operation Page 3-43 CFP83 Series Overspeed Setpoint Adjustment and Testing (Cont) Drawing No. 9777, Section 3, Rev. 02-07 Test Procedure FACTORY SETTING NOTE: The overspeed trip setpoint is displayed FACTORY SETTING on the Factory Setting Tag described in Section ENGINE SPEED SETTING: 2. (@ HP SETTING) OVERSPEED SWITCH SETTING: Start the engine. Observe that the engine starts and operates at about rated speed. NOTE: Monitor engine speed on the tachometer. Record the observed engine speed when it trips. It must trip between 115 and 120% of rated speed. NOTE: Do not exceed 120% of rated speed.
If the engine does not trip at or below 120%, stop the engine and Adjust the Speed Switch. Adjust the mechanical throttle adjustment to increase engine speed to the setpoint. Observe that the engine stops automatically and that the overspeed trip light is illuminated. Verify that the engine tripped at a speed between 115 and 120% of rated speed. Press the RESET button on the speed switch. Press the RESET switch on the front of the engine control panel. Observe that the overspeed light has extinguished. NOTE:
If required by the local authority, restart the engine at the current mechanical throttle setpoint to demonstrate a run-away overspeed shutdown as specified by Underwriter’s Laboratory UL 1247.