. OPERATION OPERATION the warming-up operation. 10 to -30 ° C (50 to -22 ° F) Change 0 to 20 Engine Cooling Water Auto Warming-up Function This is a function to automatically warm up engine cooling water more quickly by raising an engine idling speed. When the turbocharger protection function and engine cooling water auto warming-up function are activated at the same time, the former takes priority over the latter. While the turbochargerprotection function is in operation, the engine revolution is held at 1200 rpm even if the fuel control dial is set at any rpm.
However, if the fuel control dial is held at the engine full speed (MAX) for more than three seconds, the engine will gradually pick up the speed up to the full idling. This function continues to work for a maximum of 10 minutes, or until the engine cooling water temperature reaches 30 ° C (86 ° F). If the deceleration pedal is depressed while this function is in operation, the engine rpm goes down below 1200 rpm. 3 - 91 7.
When the engin e rotation stabilizes, return to the low idle (MIN) position of fuel control dial (1) and then ca rry out REMARK Regardless of t he ambient temperature, if the key in starting switch (2) is turned from OFF position to left, preheating pilot lamp (3) will light up and preheating will start. (Preheating continues w hile the starting sw itch is held at the left.) f the preheating time, see the table in Step 5. g is being carried out, the preheating pilot lamp (3) lights up to show that preheating is being es not start with the above operation, wait for about 2 minutes, and repeat steps 3. And 4. For the details o f the preheating time, see the table i While preheatin carried out.
If the engine do es not start with the above operation , wait for about 2 minutes, and re peat st eps 3. And The relationship between the actuation time of the tu rbo protect function and th e engine cool ant temperature is as follows. control dial is operated within the time given below, the engine speed will not change. Even if the fuel control dial is operated within the tim e given below, the engine speed will not Turbo protect functio n The turbo protect fu nction is a function to protect the tu rbocharger by keeping the engine speed at less tha n 1000 rpm immediately af ter the engine is started.
When the turbocha rger protection function and engine c ooling water auto warming-up fu nction a re activated at the same time, the form er takes priority over the latter. While the turboch argerprotection function is in operat ion, the engine revolution i s held a t 1000 r pm even if t he fuel control dial is set at above 1000 rpm. While the turboch argerprotection function is in operat ion, the engine revolution i s held a t 1000 r pm even if t he fuel control dial is op erated. When the turbo p rotect function is canceled, the engin e speed is set to the speed for the position of the fuel control dial.
The relationship turbo protect fun ction and the temperature of the engi is as shown in th