. OPERATION OPERATION STOPPING ENGINE 3 - 95 NOTICE If the engine is stop ped without allowing it to cool down, there is danger that the service life in emergencies, nev of various parts of the er stop the engine sud engine will be reduced. Except denly. If th allo e engine overh w it to cool dow eats, do not stop it su n gradually, then stop i ddenly. Run it at low speed to t. 1. Lower the wo rk equipment to the ground. 2. Place fuel con trol dial (1) in the low idle (MIN) posit ion and run the engine at low idle speed for about 5 minutes to allow it to l down. it to gradually coo 3. Turn the key i n ignition switch (2) to the OFF posit ion (A).
The engine w ill stop REMARK When engine starting switch (2) key is turned to the OFF engine stops, but the machine's main power urned off immediately. lag provided for the controller to memorize the us and then terminate the system. While this s position, the engine stops, but t ource is not t urned off immediatel This is a time lag provided for the us and then termin emorize the operation stat ate the system. While this process contin ues, the main powe r is maintained. The power holding time v aries depending on t he operation con dition. Also when the cooling fan is used for a cleaning p not turned off i urpose, the t s machine's ma mmediately, even if engine FF position.
This time lag i s provided to protect the hydraulic cir cuit, an d in his case, the econds. machine's main power is maintained for seven 4. Remove the k ey from starting swit