. OPERATION OPERATION OPERATION OPERATION 2. Blade control lever (2) to the full RAISE position, then hold the lever in position, and operate slowly to the left tilt relief and right tilt relief positions for 5 minutes. 3. Then operate blade control lever (2) to the full RAISE position (up to the lever stroke end) and hold it in that position; alternate the right and left TILT relief intermittently; lower the blade to the ground by operating the control lever to the LOWER position; operate the control lever to the FLOAT position (up to the lever stroke end); and alternate right and left TILT relief intermittently for five minutes. 4.
Lower the blade to the ground, move the control lever fully to the FLOAT position (lever stroke end) and hold the lever in position for 1 minute. Next, release the lever and check that it stays in the FLOAT position. After waiting for 3 minutes, return the lever to the HOLD position. 5. After warm-up run is completed, check gauges and caution lamps for proper operation. If any abnormality is found, repair it. (A) (B) (C) RAISE HOLD LOWEW (D) (E) (F) FLOAT LEFT TILT RIGHT TILT Continue to run the engine at light load until engine coolant temperature gauge indicator (3) and Hydraulic oil temperature gauge (4) fall within the green range (B). (A): White range (B): Green range (C):
Red range REMARK If the power train oil temperature is not raised sufficiently, it will take longer to accelerate to the maximum speed. 6. Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. 3 - 94