Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE CLEANING BY COOLING FAN REVERSE TURN 2. Turn starting switch (1) to the "ON" position. 3. Set fan rotation selector switch (2) to the cleaning position (CLN). Cooling fan operation checking lamp (3) lights up. REMARK 4 - 31 CLEANING AND INSPECTION OF FINS OF RADIATOR, OIL COOLER, CONDENSER AND AFTER-COOLER If the radiator fins are clogge d or dirty, clean and inspect them NOTICE When working on jobsites where as follows after completing oper the fins often become clogged, always do ations. When rotating the cooling fan in of flying dust.

the reverse direction, be extremely careful Open the engine side cover on t he left side of the machine and be careful not to let dust accumulate insid e the engine room. When rotating the fan in reverse, do not open the engine side cover on the right side of the machine. When stopping the engine when the cooling fan is rotating in the reverse direction, first run the engine at low idling, then stop it. After running the fan in the reve rse direction, check that there are no dry leaves, dust, or other flammable materials on the engine.

In particular , be careful to check that there are no dry leaves, dust, or other flammable materials around places that be come hot during operations, such as the exhaust manifold, turbocharge r, and top of the exhaust pipe. If any emove them. any flammable materials are found, r The dust and dirt stuck to the radiator and cooler can be blown out by rotating the cooling fan in o the "OFF" position and stop the engine. Even if it is attempted to reve rse a rotation direction of the cooling fan while the engine is runn changed. be In that case, cooling fan ope ration checking lamp (3) flashes a nd warns that the fan rotation ca