Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING CLEAN BREATHER 1. Open cover on the right side of the machine. 2. Remove breather(1), then use clean diesel fuel or flushing fluid to rinse the dirt out from the inside. 4 - 66 The oil is at high temperature immediately after the machine has been operated. Wait for the oil to c ool down before starting the operation. If there is still pressure remai ning inside the case, the oil or p lug may f ly Loosen the plug slowly to rel Refill capacity: 6.34US gal) s (7.13US gal) D65EX : (each) 24 liters ( D65PX,WX: (each) 27 liter 1. Stop the machine so that 2. Remove oil level plug (2 drain plugs (3) and (4), a 3.

After draining the oil, inst 4. Add oil to the specified lev 5. Check that the oil is at "CHECK OIL LEVEL IN (PAGE 4-46)". D65EX : (each) 24 liters ( D65PX,WX: (each) 27 liter 1. Stop the machine so that drain plug (3) is directly at the bottom. 2. Remove oil level plug (2 ) and oil filler plug (1), then remove nd drain the oil. all drain plugs (3) and (4). drain plugs (3) and (4), a 3. After draining the oil, inst 4. Add oil to the specified lev el through the hole in oil filler plu g (1). Check that the oil is at the specified level. For details, "CHECK OIL LEVEL IN (PAGE 4-46)".