Komatsu — EVERY 1000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE with sealing surface, then tighten approx. 2/3 turn. 5. Open valves (1) (2 places). CHECK ALL TIGHTENING POINTS OF ENGINE EXHAUST PIPE CLAMPS INSPECTION OF AFTER-COOLER CIRCUIT FOR LOOSENED BOLTS AND NUTS 4 - 67 REPLACE CORROSION RESISTOR CARTRIDGE Use Komatsu genuine cartri 1. Screw in 2 valves (1) at the top of the corrosio 2. 3. Using a filt Apply engi er wrench, tur ne oil to the se n cartridge (2 aling surface ) to the l of a new eft to remove it cartridge, then install it to When inst the filter hold alling, screw in er.

cartridge until seal comes in contac Please ask yo ur Komatsu di stributor to ch eck the tightening of th e clamps between the air cle aner - turbocharger - aftercooler - CHECK FOR LOOSE ROPS MOUNT BOLTS Check that the bolts are not loose and tha t there i s no If any b olt is lo ose, tighten it to the followin g torqu If there is any damage, repla ce the bolt wi th a genuine Komatsu part. Tightening tor que: 785 to 98 0 Nm (80 to 1 00 kgm, 578.6 to 723.3 lbft) Check each cl amp for loose ning. If any cl amp is fo und loosened, tighten