Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN HYDRAULIC TANK, REPLACE OIL FILTER ELEMENT WARNING 4 - 68 EVERY 2000 HOUR Maintenance for every 5 0, 250, 500 and 1000 h ours s ervice should be carried out at the sa The parts and oil are a t high temperature immediately after the engine is stopped, and may cause burns. Wait for the before starting the work. temperature to go down before starting the work. When removing the oil fil ler cap, oil may spurt out, so push the ca p down to release the internal pres sure, then remove the cap carefully. Refill capacity: 55 liter s (14.53 US gal) 1. Lower the work equip ment to the ground, the n stop the en gine. 2.

Push down cap of oil filler (F) to release the a ir and remov e the internal pressure. wn, turn it slowly counterclockwise, then ) at the bottom of the hydraulic tank. (2), drain the oil, tighten drain valve (2) ver (1). When loosening drain valve (2), be on yourself. 3. Keep cap pushed do remove cap. 4. Remove the cover (1 ) at the bottom of the h ydrauli c tank 5. Loosen drain valve again, then install co careful not to get oil 6. 7. 8. Remove bolt (3), the Take out spring (5), Clean the inside of t (6). n remove cover (4). valve (6), and element (7). he case, then wash spring (5) and valve 7), valve (6), and spring (5). bolt (3). 9. Install new element ( 7), valve (6), and sprin 0.

Install cover (4) with 1. Add the refill amoun t of engine oil through o il filler port (F ), then When installing cap to the tank, push it dow n, then turn i EMARK correctly, it will cause leakage of oil. f the cap is not installed correctly, it will cause l eakag e of oil When installing the cap, press the cap down, an d turn it until it is securely in contact with th 2. Check that the oil is at the specified level. F OIL (PAGE 4-47)". e "CHECK OIL LEVEL IN HY DRAULIC TANK, ADD