Weichai — Weichai 495 Series Diesel Engine Operation and Maintenance Manual

Chapter II Main Construction, Adjustment and Maintenance of the Di.esel Engine 1. Cylinder Block Assembly Cylinder block is of a rectangle gantry type. Cylinder liners of wet type are fitted in the cylinder block and rested at its upper shoulder. The top surface of the liners The main bearing caps are located by locating sleeves and machined in pair with the should be higher than the top surface of the block 0.03 -0. 08mm. corresponding bearing seats on the crankcase, so that the caps can "t be inter- changed or turned inside out. Therefore, the bearing cap is marked with number and arrowhead, and the direction of the arrowhead .is forward.

The main rod bearing is fore installing, we should apply adequate clean engine oil on the crankshaft. made of steel - backed aluminum alloy which is very thin, so it cant be lapped. Be- There are two bolts on one main bearing cap, so they should be tightened evenly by many times one by one in regulated torque, and should use tightening gaskets to lock it. In the process of using, you shouldnt make the crankshaft receive additional power. 2. Cylinder Head Assembly Cylinder head is a single piece casting structure, with independent intake and ex- with a slant throat of kidney shape 'cross - section and a small comical hole inside, is haust ports on both sides.

The combustion chamber is whirl chamber. The insert, pressed into the bottom of the swirl chamber. ·The small conical hole should be a- ligned with the nozzle center line in installation of the insert so as to make the en- gine easy' to start. Intake & exhaust valve and valve seat have been run - in when u- sing, so remember the number of cyli'nder when disassembly and assembly. When sealing condition between valve and valve seat is not good, lapping is necessary, and should be cleaned before assembly. After long time operatiqn, the width of valve seat contacting area may be over 2. 5mm, we can ream the valve seat by refer to Fig. 1. ) and 45°reamer articulated.

contact area when necessary (ZH4100 means of a 15°and 75°special reamer with a guide rod of 9mm in diameter (Please intake valve seat ring should adopt 60 o reamer) . The valve seat must be renewed if the level of the valve head is lower than ·that of the cylinder head bottom surface by more than 3. 5mm after the valve seat being reconditioned. Before a new valve seat is pressed into th,e cylinder head, a interference of O. 086 - O. 150mm in diameter 31