should be kept, and the cylinder head should be heated integrally to about 2000C tact area to make it at 1.3 -·1. 5mm in width, valve setting value is 0.6 -1. Omm when assembly. Then the valve seat can be in -laid, and ream and lap it at the con- down. Fig. 1 Dlagram of reconditioning valve seat There are cylinder heat gaskets between the cylinder and the cylinder block. And the cylinder head is fastened to the cylinder block by 18 bolts. The cylinder head bolts should be tightened evenly by three times one by one in regulated order and torque. (Fig. 2) Fig. 2 The sequence of tightening cylinder head bolts 3.
Piston and Connecting Rod Assembly The piston and connecting rod assembly are constituted by piston, piston ring, pis- · 32 ·