ton pin, connecting rod, connecting rod bearing and connecting rod screw. Each piston of diesel engine has three compression rings and one scraper ring. The first compression ring is barrel chrome - plate ring of modular cast iron, to improve the abrasive resistance under high temperature. The second ring is taper - face ring third compression ring is distorting ring. The side with distorting groove should be with the word II topll on the side which should be upward when assembled. The faced downward. The scraper ring is a component with inner spiral spring.
As as- sembling scraper ring, the opening of the inner spiral spring maintaining reed should be at the opposite side of the opening of scraper ring. As assembling piston ring, out if the opening clearance is in the specified scope. If clearance is too small, re- first it should be put in cylinder liner, then be checked with clearance· gauge to find pair with file. The three piston rings should be staggered 120°C with each other, and meanwhile avoid the direction of piston pin hole. See to Fig. 3. IXO" -I~~.~ ----.. ... "'-. --~ ,." Fig.
3 The opening clearance of piston rings in cylinder liner The piston pin is full floating type, and can be rotate in piston pin hole as it getting to certain working temperature, to make wearing evenly. But it is cool, it is interfer- ence fit between piston pin and the piston pin hole. So when assemble and disas- semble the piston pin, the piston should be preheated to 100 - 120°. Assemble pis- ton pin by force at cool temperature is prohibited, otherwise the pinhole may be ru- ined. The big end of connecting rod has a 45° inclined cut. Connecting rod body and con- necting rod cap have marking numbers at same side. When assembled, the number must be registered.
The small end of connecting rod has a copper bushing. The oil 33