hole on the bushing should be right aligned t~ the oil gathering hole at the top of are self - locked by friction force. The mass difference of connecting rod for one connecting rod small end, to lubricate piston pin and bushing. Connecting rod bolts same diesel engine is less than 20g, and that of piston and connecting rod assembly for one same diesel engine is not bigger than 30g. The connecting rod bearing is usually made of thin steel - backed aluminum alloy When we assembling the connecting rod, the short side on the 45° inclined face material, so it cant be lapped. should be at the same side with the groove of the combustion chamber on the top of the piston.
When the piston is installed in the cylinder liner, the combustion chamber should be at the same side with the nozzle. 4. Crankshaft And Flywheel Assembly The crankshaft and the flywhee1 assembly is constituted by crankshaft, flywheel, crankshaft timing gear, crankshaft pulley and starting dog etc. The crankshaft is made of modular cast iron and has four connecting rod shaft neck and five main shaft necks. All the surface of shaft necks is quenched or intruded, to improve the wearing resistance. The front and rear end are sealed by skeleton structure rubber oil seal. Theres a re- tainer ring installed in front of the oil seal to .assure the seal liability.
Flywheel is positioned by dowel pin, and fastened on the rear end of crankshaft by six high strength bolts. Flywheel bolts should be tightened gradually according to the sequence shown in Fig. 4. Fig. 4 The tighten sequence of flywheel · 34·