The diesel engine takes out power through flywheel, supporting disc, pressure disc A. The clearance between the release lever and the release shaft should be 3mm. and driven plate putout shaft. A flat belt pulley, V - belt pulley or a coupler can be installed at the output shaft end. The front end of the clutch output shaft is supported on the' flywheel bearing, the bearing and the seat are installed on the front bearing cover. There are three pulling rear end is supported on the two bearings inside the clutch housing. The release ears on the pressure disc stretched out of the supporting disc, on which installed three release lever.
When the control lever is moved forward, the release yoke pu- ver, and press the lever to overcome the pressure of the spring and leave the driven shes the release bearing move forward, the release bearing contacts the release le- plate, finally cut the power. 12. The Main Changed Parts of K4100 Diesel Engine K4100 diesel engine is developed on the basis of 495 through cylinder expansion. The cylinder block, cylinder liner, water seal ring, cylinder cover gasket, piston and piston ring are newly designed. They can be in common use with 495 diesel engine. 13.
The 'Main Changed Parts of ZH4100 Diesel Engine ZHlI00 diesel engine is developed on the basis of K4100 by the changing of direct in- jection. The main changed parts are cylinder head, fuel pump, injector, high pres- sure pipe, inlet pipe ,piston and piston ring etc. 43