Komatsu — WHEEL MOTOR SERVICE

Lubrication and Service - Section 40 OM4051 Page 40-2 Engine coolant must always be visible in the sight gauge before truck operation. COOLING SYSTEM SERVICE Check the coolant sight gauge. If coolant cannot be seen in the sight gauge, it is necessary to add coolant to the system before truck operation. Refer to the procedure below for the proper filling procedure. Adding Coolant The cooling system is pressurized due to thermal expansion of coolant. Do not remove the radiator cap while the engine and coolant are hot. Severe burns may result. NOTE: If coolant is added using the Wiggins service center, the radiator cap must still be removed before adding coolant. 1.

With the engine and coolant at ambient temperature, remove the radiator cap. 2. Fill the radiator with the proper coolant mixture (as specified by the engine manufacturer) until coolant is visible in the sight gauge. 3. Install the radiator cap. 4. Run the engine for five minutes, then check the coolant level. 5. If coolant is not visible in the sight gauge, repeat Steps 1 - 4. Any excess coolant will be discharged through the vent hose after the engine reaches normal operating temperature. WHEEL MOTOR SERVICE Due to differences in gear ratio and component evolution/design, wheel motor service intervals may be unit number and/or mine specific.

Because of the wide variety of factors involved, it is necessary to consult your area Komatsu representative for all wheel motor service intervals and instructions. General intervals for oil service and sampling are listed in the interval charts. FIGURE 40-2. COOLING SYSTEM SERVICE 1. Sight Gauge 2. Radiator Cap COOLING SYSTEM ANTI-FREEZE RECOMMENDATIONS (Ethylene Glycol Permanent Type Anti-Freeze) Percentage of Anti-Freeze Protection To: 10 + 23° F (- 5° C) 20 + 16° F (- 9° C) 25 + 11° F (- 11° C) 30 + 4° F (- 16° C) 35 - 3° F (- 19° C) 40 - 12° F (- 24° C) 45 - 23° F (- 30° C) 50 - 34° F (- 36° C) 55 - 48° F (- 44° C) 60 - 62° F (- 52° C) NOTE:

Only use anti-freeze that is compatible with the engine. Refer to the engine operation and maintenance manual.