OM4051 Lubrication and Service - Section 40 Page 40-3 Oil should always be visible in the bottom sight gauge. If not, add oil to the reserve oil tank until oil is visible in the top sight gauge. RESERVE OIL TANK SERVICE The engine oil reserve system is designed to add more oil capacity to the engine to reduce the frequency of servicing of the engine oil. The engine oil level must be checked before every shift using the dipstick. If the engine oil level is not correct, check the operation of the engine oil reserve system. Never add oil to the engine unless it has been completely drained. If the engine oil has been drained from the oil pan, new oil must be added to the oil pan.
Do not use the oil in the reserve oil tank to fill an empty engine oil pan. With the engine running, check the operation of the red LED light on the pump. After an oil change, both the engine and reserve oil tank must be full of oil before starting the engine. Continuously on - Pump 1 is withdrawing oil from the engine sump and bringing down the oil level. Regular pulsing - Pump 2 is returning oil to the engine sump and raising the oil level. Filling the Reserve Oil Tank (Remote Fill) 1. Connect the supply hose from the new oil supply to the quick disconnect coupling on the truck. Open the valve on the supply hose to apply pressure. Irregular pulsing - Oil is at the correct running level. 2.
Pull power switch (2, Figure 40-1) to turn the system ON. 3. Push start switch (3). VALVE OPEN light (5) should illuminate and the filling process will begin. 4. When tank is full, VALVE OPEN light (5) will turn off and FULL light (4) will illuminate. 5. Close the valve in the supply hose. 6. Press and hold start switch (3) for a couple of seconds. 7. Disconnect the supply hose from the quick disconnect coupling on the truck. 8. Push power switch (2) to turn the system OFF. Inline Screen FIGURE 40-3. REMOTE FILL CONTROL BOX There is an inline screen located at the inlet of the fill valve.
This screen does not require periodic maintenance, but it can be cleaned by removing the screen and back flushing. 1. Remote Control Box 2. Power Switch 3. Start Switch 4. FULL Light 5. VALVE OPEN Light