OM3063 Operating Instructions - Section 30 Page 30-3 13. Move around the hydraulic tank and in front of the rear dual tires. Inspect the hoist cylinder for any damage and leaks. Ensure that both upper and lower hoist cylinder pins are secure and properly greased. FIGURE 30-1. TOP VIEW 1. Operator Cab 2. Auto Lubrication 3. Radiator 4. Reserve Oil System 5. Engine 6. Fuel Filters 7. Suspension 8. Wet Disc Brake 9. Brake Accumulators 10. Hoist Filters 11. Steering Filter 12. Fuel Tank 13. Hoist Cylinder 14. Rear Axle Housing 15. Wet Disc Brake 16. Wheel Motor Transmission 17. Rear Tires 18. Rear Suspension 19. Rear Axle Hatch 20. AC Electric Motor 21. Hydraulic Tank 22. Steering Pump 23.
Hoist Pump 24. Steering Accumulators 25. Alternator 14. Look under the lower edge of the chassis to ensure that the flexible duct that carries the air from the main blower to the final drive housing is in good condition. Also look up at the main hydraulic pumps to see if there is any leakage or any other unusual condition with the pumps or pump drive shafts. 15. Move around the left side dual tires. Check that all wheel nuts/studs are in place and tight. Inspect the wheel for any oil that would indicate brake leakage or wheel motor leakage. 16. Check the dual tires for cuts, damage, and bubbles. Verify that tire inflation is correct.
If the truck has been run on a "flat," the tire must be cooled before moving the truck inside. Check for any rocks that might be lodged between the dual tires. 17. Inspect the left rear suspension for damage, correct rod exposure, and leaks. Ensure that the covers over the chrome piston rod are in good condition. 18. While standing at the rear hatch, look up to check that the rear lights and back-up horns are in good condition. Look up at panhard rod to check that it is properly greased. Also check both body hinge pins for proper greasing and any abnormal condition. Check the hoist limit switch and clear any mud or debris from the contacts. 9. Move outside of the front wheel.
Ensure that all of the wheel attaching nuts/studs are in place and tight. Check the tires for cuts, damage, or bubbles. Check for evidence of incorrect tire inflation. 10. Move in behind the front wheel. Check that the steering cylinder is properly greased and the attaching hardware is tight. Check the suspen- sion attaching hardware and suspension exten- sion. Ensure that the suspension protective boot is in good condition. Inspect the hub and brakes for any unusual conditions. Check the entire area for leaks. 19. Perform the same inspections on the right rear suspension. 20. Move around the right side dual tires. Inspect between the tires for rocks.
Inspect the tires for cuts, damage and proper inflation. 21. Check that all wheel nuts/studs are in place and tight. Inspect the wheel for any oil that would indicate brake leakage or wheel motor leakage. 11. Inspect the sight glass on hydraulic tank (21). With the engine stopped and the body down, hydraulic fluid must be visible in the upper sight glass. 22. Move in front of right dual tires. Inspect the hoist cylinder in the same manner as the left side. Ensure the body-up limit switch is secure and in good condition. Remove any mud or dirt accumulation from the switch. 12. If equipped, verify that all hydraulic tank shut off valves are locked in their fully open positions.