Operating Instructions - Section 30 OM3063 Page 30-4 23. Move around fuel tank (12). Inspect the fuel gauge. This should agree with the fuel gauge in the cab. Inspect the attaching hardware for the fuel tank at the upper saddles and at the lower back side of the tank. Check the hoist filters for leaks. 30. Always use handrails and ladders when mounting or dismounting the truck. Clean any foreign material such as ice, snow, oil or mud from the ladders and handrails. 24. Move in behind the right front wheel. Check that the steering cylinder is properly greased and the attaching hardware is secure. Check the suspension attaching hardware and suspension extension.
Ensure that the suspension protective boot is in good condition. Inspect the hub and brakes for any unusual conditions. Check the entire area for leaks. If the engine has been running, allow the coolant to cool before removing the fill cap or draining the radiator. Serious burns may result if skin comes in contact with hot coolant. 31. Use the coolant level sight gauge to check the coolant level in the radiator. If it is necessary to remove the radiator cap, ensure the engine is shut down and relieve coolant pressure by slowly removing the radiator cap. 25. Move out and around the right front wheel. Check that all wheel nuts/studs are in place and tight. 26.
Move behind the front of the right front wheel. Check the hub and brakes for leaks and any unusual conditions. Check that the steering cylinder is secure and properly greased. Inspect the engine compartment for any leaks and unusual conditions. Inspect the fan guard and belts. Check the fuel filters for leaks. Check for any debris behind the radiator. 32. Inspect the retarding grid and covers. Ensure that the latches are in place and secure. Inspect the main air inlet to be sure it is clear. Ensure that all cabinet door latches are secure. 33. Check the coolant level in the inverter cabinet radiator. The coolant level must be visible at the halfway mark in the upper sight gauge. 27.
Move around to the right front of the truck. Empty the dust collectors on the right side air cleaner assemblies. (A ladder may be necessary to reach the air cleaners.) Check the oil level in reserve tank (4). 34. Move around to the rear of the cab. Open the doors of the brake cabinet and check inside the cabinet for leaks. 35. Clean the cab windows and mirrors. Clean out the cab floor, if necessary. Ensure that the steering wheel, operator controls, and pedals are free of any grease or mud. 28. As you move in front of radiator (3), remove any debris that is stuck in front of the radiator. Check for any coolant leaks. Inspect the headlights and fog lights. 36.
Stow any personal gear in the cab so that it does not interfere with any operation of the truck. Dirt or trash buildup, specifically in the operator's cab, should be cleared. Do not carry tools or supplies in the cab or on the deck. 29. Before climbing the ladder to first level, ensure that the ground level engine shutdown switch is activated. If equipped, inspect the fire control actuator. Ensure that the safety pin is in place and the plastic tie that prevents accidental actuation is in place and in good condition. Ensure that the battery disconnect switches are activated. 37. Adjust the seat and the steering wheel for the operator’s comfort. 38.
Before operating the truck, read about and understand the locations and functions of all operator controls listed in Section 32, Operator Cab And Controls. Always mount and dismount ladders facing the truck. Never attempt to mount or dismount while the truck is in motion.