Komatsu — ENGINE START-UP

OM3063 Operating Instructions - Section 30 Page 30-5 ENGINE START-UP NOTE: This truck is equipped with an engine prelube system. With this feature, a noticeable time delay may occur before engine cranking begins as the engine lube oil passages are being filled and pressurized. Never attempt to start the engine by shorting across the starter terminals. This may cause fire, or serious injury or death to anyone in the machine’s path. Start the engine from the operator seat only. 5. After the engine has started, place the rest switch in the OFF position to deactivate the rest mode. NOTE:

In cold ambient conditions and when the engine is cold, the engine rpm will not increase above low idle speed until the engine controller determines it is safe to do so. This time delay will vary from 30 seconds to 11 minutes which allows the coolant and engine oil to warm up. If the truck is in an enclosure, make sure that there is adequate ventilation before start-up. Exhaust fumes are dangerous! NOTE: The electric cranking motors have a 30 second time limit. If the 30 second limit is reached, cranking will be prohibited for two minutes. After two minutes, cranking will be allowed. If the 30 second limit is reached seven consecutive times, the key switch must be turned to the OFF position.

This will allow the interface module to power down and reset, which requires seven minutes to complete. A warning will be displayed in the monitor panel if the 30 second time limit or seven attempts is reached. If the truck is equipped with an auxiliary cold weather heater system, do not attempt to start the engine while the heaters are in operation. Damage to the coolant heaters will result. 1. Ensure that all personnel are clear of the truck before starting the engine. Always sound the horn as a warning before moving any controls. 2. Make sure that the directional control lever is in PARK before starting. 3. Place the rest switch in the ON position to put drive system in rest mode.

For more information, refer to the Section 32 - Operator Cab And Controls. 4. The key switch is a three-position switch (OFF, RUN, START). a. Turn the key switch one position clockwise to the RUN position. All electrical circuits except the start circuit are activated. Verify that all indicator lights and gauges are functioning. b. After the message “System Initializing” is displayed, turn the key switch fully clockwise to the START position and hold this position until the engine starts. The START position is spring-loaded and will return the switch to the RUN position when the key is released.