OM3063 Operating Instructions - Section 30 Page 30-7 b. Steering accumulator precharge: Verify that the low accumulator precharge message is not displayed on the dash panel and the warning buzzer is not sounding. If the message is displayed and the buzzer is sounding, immediately notify maintenance personnel. Do not operate the truck until the problem is corrected. EMERGENCY STEERING SYSTEM Operation This truck is equipped with an emergency steering system. This system is a backup in the event of loss of oil supply to the main steering system. The emergency steering system was designed to meet or exceed SAE J1511 and ISO 5010 standards.
If the low steering system pressure indicator light and alarm are activated, a failure in the hydraulic oil supply to the steering and brake system exists. When the alarm is activated, typically there is enough hydraulic pressure stored in the brake and steering accumulators to allow brief operation of the steering and brake functions. However, this oil supply is limited. Therefore, it is important to stop the truck as quickly and safely as possible after the alarm is first activated. 5. Start the engine and allow the steering accumulators to fully charge. Turn the steering wheel so that the front wheels are straight. 6. Check the hydraulic tank oil level while the engine is on. a.
If the oil level is visible in center of the lower sight glass and does not cover the entire lower sight glass, the steering accumulators are adequately charged. Proceed to Step 7. If the oil supply pressure drops to a predetermined level, the low brake pressure warning light will also illuminate. If the oil pressure continues to decrease, the brake auto-apply feature will activate the service brakes to stop the truck. b. If the oil level is below the lower sight glass, the steering accumulators are not adequately charged. Stop the engine and turn the key switch to the OFF position. Immediately notify maintenance personnel. Do not operate the truck until the problem is corrected.
Pre-Operation Testing 7. If the steering accumulators are adequately charged, stop the engine by using the engine shutdown switch. Leave the key switch in the ON position. This allows the steering accumulators to retain their hydraulic charge. The low steering pressure warning light and the low accumulator precharge warning light should not illuminate. NOTE: Komatsu recommends that operators perform this test to verify that the steering accumulator precharge pressure is adequate at the beginning of each shift before operating the truck. 1. Park the empty truck on flat, level ground. Lower the dump body onto the frame and stop the engine. Make sure that the key switch is in the OFF position.
8. Turn the steering wheel from stop to stop. The front wheels should turn fully to the left and to the right. Also, the low steering pressure warning light should illuminate and the warning buzzer should sound. If the front wheels cannot be turned fully to the left and right, or if the warning light and buzzer do not activate, immediately notify maintenance personnel. Do not operate the truck until the problem is corrected. 2. Wait at least 90 seconds to verify that all hydraulic pressure has been relieved from the steering accumulators. Turn the steering wheel from stop to stop. If the front wheels do not move, there is no hydraulic pressure. 3. Check the hydraulic tank oil level.
The oil level must be visible in the center of the upper sight glass and must not cover the entire upper sight glass. Add oil if necessary. Do not overfill. 4. Turn the key switch to the ON position, but do not start the engine. If the truck passes this test, the emergency steering system is functioning properly. a. Steering system pressure: Verify that the low steering pressure message is displayed on the dash panel. If it is not displayed, immediately notify maintenance personnel. Do not operate the truck until the problem is corrected.