Operating Instructions - Section 30 OM3063 Page 30-8 Match the truck speed to haul road conditions. Slow down the truck in congested areas. Keep a firm grip on the steering wheel at all times. PRECAUTIONS DURING TRUCK OPERATION After the engine is started and all systems are functioning properly, the operator must follow all local safety rules to ensure safe machine operation. Do not allow the engine to run at idle for extended periods of time. When the truck body is in the dump position, do not allow anyone beneath it unless the body-up retaining pin or cable is in place.
If the red warning light comes on or if any gauge reads in the red area during truck operation, a malfunction is indicated. Stop the truck as soon as possible and turn off the engine. Have the problem corrected before resuming truck operation. Do not use the brake lock for parking. With the engine stopped, hydraulic pressure will bleed down, allowing the brakes to release. Check the brake lock performance periodically for safe loading and dump operation. Proceed slowly on rough terrain to avoid deep ruts or large obstacles. Avoid traveling close to soft edges or the edge of a fill area. The truck is equipped with "slip/slide" control.
If this function becomes inoperative, operating the truck with stalled or free spinning wheel motors may cause serious damage to the wheel motors. If the truck does not begin to move within 10 seconds after depressing the throttle pedal with the directional control lever in a drive position, release the throttle pedal and allow the wheels to regain traction before accelerating again. Do not drive over unprotected power cables. Check the tires for proper inflation periodically during your shift. If the truck has been run on a “flat” or under-inflated tire, it must not be parked in a building until the tire cools. Operate the truck only while properly seated with seat belt fastened.
Keep hands and feet inside the cab while the truck is in operation. Do not allow unauthorized personnel to ride in or on the truck. Do not allow anyone to ride on the ladder of the truck. Always look to the rear before backing the truck. Watch for and obey the ground spotter's hand signals before making any reverse movements. The spotter should have a clear view of the entire area at the rear of the truck. When backing up the truck, give a back-up signal of three blasts on the horn. When starting forward, give two blasts on the horn. These signals must be given each time the truck is moved forward or backward. Truck operation requires concentrated effort by the driver.
Avoid distractions of any kind while operating the truck. Check the gauges and instruments frequently during operation for proper readings. Observe all regulations pertaining to the job site's traffic pattern. Be alert to any unusual traffic pattern. Obey the spotter's signals.