Komatsu — STARTING ON A GRADE WITH A LOADED TRUCK

OM3063 Operating Instructions - Section 30 Page 30-9 OPERATING ON A HAUL ROAD Always stay alert! If you are unfamiliar with the haul road, drive with extreme caution. The cab doors should remain closed at all times if the truck is in motion or unattended. STARTING ON A GRADE WITH A LOADED TRUCK Initial propulsion with a loaded truck should begin from a level surface whenever possible. However, the truck is equipped with an anti-roll feature to assist on hill starts without any truck rollback. Obey all road signs. Keep the truck under control at all times. Govern the truck speed according to the road conditions, weather, and visibility. Report poor haul road conditions immediately.

Muddy or icy roads, pot holes, or other obstructions can present hazards. This feature automatically activates the brake lock solenoid if the truck is on an incline and stationary, with the engine running and the directional control lever in forward or reverse position. The brake lock solenoid will deactivate once the throttle pedal is depressed at least 50% and enough torque is built up to move the truck. Initial propulsion with a loaded truck should begin from a level surface whenever possible. If starting on a hill or grade cannot be avoided, refer to "". Use extreme caution when approaching a haul road intersection. Maintain a safe distance from oncoming vehicles.

Maintain a safe distance when following another vehicle. Never follow another vehicle in the same lane closer than 15 m (50 ft), or 30 m (100 ft) on a downgrade. Do not pass another truck on a hill or blind curve. Only use areas designated for passing. Before passing, make sure that the road ahead is clear. If a disabled truck is blocking your lane, slow down and pass with extreme caution. Do not stop or park on a haul road unless it is unavoidable. If you must stop, move the truck to a safe place, move the directional control lever to PARK and turn off the engine before leaving the cab. Chock the wheels securely and notify maintenance personnel for assistance.

Before driving uphill or downhill, maintain a speed that will ensure safe driving and provide effective retarding under all conditions. Refer to the grade/speed chart in the operator cab to determine the maximum safe truck speeds for descending various grades with a loaded truck. When operating the truck in darkness, or when visibility is poor, do not move the truck unless all headlights, clearance lights, and tail lights are on. Do not back up the truck if the backup horn or lights are inoperative. Always dim the headlights when meeting oncoming vehicles.

If the warning light on the dash panel illuminates and a warning message is displayed on the dash panel during operation, steer the truck immediately to a safe area away from other traffic, if possible, and stop the truck.