Komatsu — Raising The Dump Body

Operating Instructions - Section 30 OM3063 Page 30-10 LOADING THE DUMP BODY 1. Pull into the loading area with caution. Remain at a safe distance while the truck ahead is being loaded. DUMPING A LOAD Raising The Dump Body 1. Pull into the dump area with extreme caution. Make sure the area is clear of persons and obstructions, including overhead utility lines. Obey signals directed by the spotter, if present. 2. When approaching or leaving a loading area, watch out for other vehicles and personnel working in the area. 3. When pulling in under a loader or shovel, follow the spotter or shovel operator’s signals.

The truck operator may speed up loading operations by observing the location and loading cycle of the truck being loaded ahead, then follow a similar pattern. 2. Avoid unstable areas. Stay a safe distance from the edge of the dump area. 4. During loading, the operator must stay in the cab with the engine running. Place the directional control lever in NEUTRAL and apply the brake lock. To prevent tipping or rolling, position the truck on a solid, level surface before dumping. As the body raises, the truck center of gravity will move. 3. Carefully maneuver the truck into the dump position.

When backing the truck into the dump position, use only the foot-operated brake pedal to stop and hold the truck. Do not rely on the wheel brake lock to stop the truck. This control is not modulated and applies the rear service brakes only . 5. When loaded, pull away from shovel as quickly as possible but with extreme caution. 4. When the truck is stopped and in the dump position, apply the brake lock and move the directional control lever to NEUTRAL. Dumping very large rocks (10% of payload or greater) or sticky material (loads that do not flow freely from the body) may allow the material to move too fast and cause the body to move rapidly and suddenly.

This sudden movement may jolt the truck violently, possibly causing injury to the operator and/or damage to the hoist cylinders, frame, and/or body hinge pins.