Komatsu — Lowering The Dump Body (on flat ground)

OM3063 Operating Instructions - Section 30 Page 30-11 It is very likely when dumping on flat ground that the dumped material will build up enough to prevent the body from lowering. In this case, the truck will have to be driven forward a short distance (just enough to clear the material) before the body can be lowered. Lowering The Dump Body (on flat ground) 1. Move the directional control lever to FORWARD, release the brake lock, depress the override button, and drive just far enough forward for the body to clear the material. 2. Stop, move the directional control lever to NEUTRAL, and apply the brake lock. 5. Pull the lever to the rear to actuate the hoist circuit.

Releasing the lever anywhere during “hoist up” will hold the body at that position. 3. Move the hoist lever forward to the LOWER position. Release the lever to place the hoist control valve in the FLOAT position, which allows the body to return to the frame. 6. Raise the engine rpm to accelerate the hoist speed. If dumping very large rocks or sticky material, slowly accelerate the engine to raise the body. When the material starts to move, release the hoist lever to the HOLD position. If the material does not continue moving and clear the body, repeat this procedure until the material has cleared the body.

If dumped material builds up at the rear of the body and the body cannot be lowered, then per- form the following steps: a. Move the hoist lever back to the RAISE posi- tion to fully raise the dump body. Then release the hoist lever so it returns to the HOLD position. 7. Reduce the engine rpm as the last stage of the hoist cylinder begins to extend. Let the engine go to low idle as the last stage reaches half- extension. b. Move the directional control lever to FOR- WARD, release the brake lock, depress the override button, and drive forward to clear the material. 8. Release the hoist lever as the last stage of the hoist cylinder reaches full extension. c.

Stop, move the directional control lever to NEUTRAL, apply the brake lock, and lower the body. 9. After the material being dumped clears the body, lower the body to the frame. NOTE: If the directional control lever is in REVERSE when the dump body is raised, reverse propel is inhibited. To deactivate, lower the dump body and move the directional control lever out of REVERSE. NOTE: Failure to hoist the body after making an unsuccessful attempt at lowering the body may result in the dump body suddenly lowering after the truck has pulled ahead of the material that was previously preventing the body from lowering. Do not move the truck with the dump body raised except in an emergency.

Failure to lower body before moving truck may cause damage to hoist cylinders, frame and/or body hinge pins. 4. With the body returned to frame, move the directional control lever to FORWARD, release the brake lock, and leave the dump area carefully.