Komatsu — USING THE SPEED CONTROL FEATURE

Operating Instructions - Section 30 OM3063 Page 30-12 Lowering The Dump Body (over a berm or into a crusher) USING THE SPEED CONTROL FEATURE The speed control feature functions much like cruise control in a car. The truck must be travelling faster than 5 kph (3 mph) before speed control will engage, and the set speed must be above 8 kph (5 mph). 1. Move the hoist lever forward to the DOWN position. Release the lever to place the hoist control valve in the FLOAT position, which allows the body to return to the frame. 1. Press the speed control switch on the dash panel to turn on the speed control feature.

If dumped material builds up at the rear of the body and the body cannot be lowered, perform the following steps: 2. Accelerate to the desired truck speed. 3. Press the button on the end of the speed control lever to set the cruising speed at the current truck speed. a. Move hoist lever back to the HOIST position to fully raise the dump body. Release the hoist lever so it returns to the HOLD position. The set speed can be increased incrementally by 1 kph (1 mph) by tapping up on the lever or continuously by holding the lever up. NOTE: Do not drive forward if the tail of body will not clear the crusher wall in the fully raised position. b.

Move the directional control lever to FOR- WARD, release the brake lock, depress the Override button, and drive forward to clear the material. The set speed can be decreased incrementally by 1 kph (1 mph) by tapping down on the lever or continuously by holding the lever down. If the accelerator pedal is used to accelerate the truck above the set speed, the truck will return to the set speed when the pedal is released. c. Stop, move the directional control lever to NEUTRAL, apply the brake lock and lower the body. If the service brake pedal is used to decelerate the truck below the set speed, tapping up on the lever will return the truck to the set speed when the pedal is released. NOTE:

Failure to hoist the body after making an unsuccessful attempt at lowering the body may result in the dump body suddenly lowering after the truck has pulled ahead of the material that was previously preventing the body from lowering. Do not move the truck with the dump body raised except in an emergency. Failure to lower the body before moving the truck may cause damage to the hoist cylinders, frame and/or body hinge pins. 2. With the body returned to the frame, move the directional control lever to FORWARD, release the brake lock, and leave the dump area carefully.