Komatsu — NORMAL ENGINE SHUTDOWN PROCEDURE

OM3063 Operating Instructions - Section 30 Page 30-13 SAFE PARKING PROCEDURE Continue to use safety precautions when preparing for parking and engine shutdown. NORMAL ENGINE SHUTDOWN PROCEDURE 1. Stop the truck out of the way of other traffic on a level surface. Make sure that there are no overhead power lines or other obstructions in case the dump body must be raised. If the truck is being used in consecutive shifts, any questionable truck performance the operator may have noticed must be checked by maintenance personnel before the truck is released to another operator. 2. Reduce the engine speed to idle. 1. Park the truck on level ground, if possible.

If the truck must be parked on a grade, position the truck at a right angle to the grade. 3. Place the directional control lever in PARK. Make sure that the parking brake applied indicator light is illuminated. 2. The directional control lever must be in PARK and chocks must be placed in front of and behind the wheels so the truck cannot roll. Each truck should be parked at a reasonable distance from one another. NOTE: If the truck starts to roll, apply the service brakes and notify maintenance personnel immediately. 4. Place the rest switch in the ON position to put the AC drive system in rest mode. The NO DC LINK VOLTAGE status light and the NO PROPEL status light should be illuminated. 5.

Turn the key switch to the OFF position. A shutdown timing sequence will be activated automatically to allow the engine to cool down before it is turned off. The timing sequence may last up to three minutes. If the engine does not shut down after three minutes, use the engine shutdown switch on the operator cab center console. Pull this switch up until the engine stops. Do not activate the wheel lock feature when the parking brake is activated. Bleed down of hydraulic pressure may occur, causing the truck to roll away. 3. Haul roads are not safe parking areas. In an emergency, pick the safest spot that is most visible to other machines in the area.

If the truck becomes disabled where traffic is heavy, mark the truck with warning flags in daylight or flares at night. 6. With the key switch OFF and engine stopped, wait at least two minutes. If any warning mes- sages are displayed, notify maintenance per- sonnel immediately. 7. Ensure the steering circuit is completely bled down by turning the steering wheel back and forth several times. No front wheel movement will occur when hydraulic pressure is relieved. If the front tires continue to steer after the engine is stopped, notify maintenance personnel. 8. Open the access panel at the left front side of the control cabinet.

Verify that the green link voltage light is illuminated and the DC bus volt- age gauge reads 0.0 V. Notify qualified drive system maintenance personnel if the green link voltage light fails to illuminate within five min- utes after engine shutdown. 9. Close and lock all windows. Remove the key from the key switch and lock the cab to prevent unauthorized truck operation. Dismount the truck properly. Put wheel chocks in place behind and in front of each tire.