OM3063 Operating Instructions - Section 30 Page 30-17 10. Ensure the operator in the towing vehicle has 2- way radio communications with the driver in the disabled truck. DISABLED TRUCK OPERATION Refer to the shop manual for repair and troubleshooting procedures for the hoist system components and steering system components. Refer to the shop manual for repair and troubleshooting procedures for the hydraulic brake system components. 11. When ready to tow the disabled truck, remove blocking from the wheels. 12. The operator in the disabled truck should now move switch (1, Figure 30-3) to the ON position. This will release the parking brakes.
Quick disconnect fittings (1 and 2, Figure 30-5) can be installed to allow operation of the steering and brake circuits for temporary truck operation if the steering/brake pump is not operational. Once these fittings are installed, two hoses (supply and return) must be connected to a hydraulic source (such as an operational truck or an auxiliary power unit) to use this feature. 13. Tow the disabled truck. Sudden movement may cause tow bar failure. Smooth, gradual truck movement is preferred. Do not tow the truck any faster than 8 kph (5 mph). 14. Minimize the tow angle at all times. Never exceed 30 degrees. The towed truck must be steered in the direction of the tow bar. 15.
When the desired location has been reached, the operator in the towed vehicle is to apply the service brakes, then turn switch (1) to the OFF position. This will apply the parking brakes. Components Required The following parts will be needed to install quick disconnect fittings that will allow the use of alternate hydraulic power source. 16. Block the wheels on the towing vehicle and the disabled truck to prevent roll-away. 1. Stop the truck engine and wait two minutes to allow the hydraulic system pressure to bleeddown. 17. Shut down the engine in the towing vehicle. Disconnect the hydraulic hoses. 18. Disconnect special wiring harness (3) from the truck.
Connect the truck wiring harness back to the parking brake solenoid. 2. Remove the plug and install the necessary QD supply fittings listed in Table 1 into the QD Supply port on the bleeddown manifold. 19. Disconnect the tow bar. Table 1: QD Supply Fittings Qty Part Number Description 1 PB4686 Dust Cover 1 PB4683 Disconnect Fitting 1 VN3308 Swivel Adapter 1 WB0593 Fitting