OM3063 Operating Instructions - Section 30 Page 30-19 DISABLED TRUCK DUMPING PROCEDURE Raising the body 1. On the disabled truck, move the hoist control lever to power up and then release it to place the hoist pilot valve in the HOLD position (leave in this position during entire procedure). Sometimes it is necessary to dump a load from the body of a truck if the hoist system is inoperable. The following instructions describe the use of a “good” truck to provide the hydraulic power required to raise the body of the “disabled” truck to dump the load. 2.
On the good truck, start the engine, place the hoist control in the LOWER position and increase the engine rpm to high idle to dump the disabled truck. Figure 30-6 illustrates a typical hookup from the good truck. The disabled truck may be the same truck model or a different Komatsu truck model. 3. If the body of the disabled truck fails to raise, increase the power down relief pressure of the good truck as follows and repeat Step 2: a. Turn off engine and allow the hydraulic system to depressurize. b. Remove the cap from the hoist pilot valve relief valve located in the hydraulic brake cabinet.
While counting the number of turns, slowly turn the relief valve adjustment screw clockwise until it bottoms. Lowering the body 1. Place the hoist lever of the good truck in FLOAT to lower the body. If necessary, momentarily place the hoist control in RAISE until the body is able to descend in FLOAT. Do not accelerate the engine. FIGURE 30-6. PUMP MODULE, HOSE HOOKUP 1. Hoist Valve 2. Tubes to LH Hoist Cylinder 3. Power Down Quick Disconnect 4. Power Up Quick Disconnect 5. Overcenter Manifold 2. After the body is lowered, turn off the engine, allow the hydraulic system to depressurize, and disconnect the hoses. Hookup 3.
If necessary, reduce the power down relief valve pressure of the good truck to normal by turning the adjustment counterclockwise the same number of turns as required in Step 2 of "Raising the body". 1. Make sure that there is an adequate, clear area to dump the loaded body. Park the good truck as close as possible to the disabled truck. 2. Turn off the engine and allow the hydraulic system to depressurize before connecting the hoses. 4. Check the power down relief pressure of the good truck. Refer to Testing and adjusting section Steering, brake cooling and hoist hydraulic system . 3.
Attach a hose from power up quick disconnect (4, Figure 30-6 ) to the power down circuit of the disabled truck. 5. Check the hydraulic tank oil level. Add oil, if necessary. NOTE: The hose for the power up circuit must be rated for at least 17 000 kPa (2,500 psi). The power down circuit will use a smaller diameter hose. 4. Connect another hose from power down quick disconnect (3) to the power up circuit of the disabled truck. NOTE: If both trucks are the same model, the hoses will be installed at the quick disconnects shown in Figure 30-6 and will be crossed when connected.