Komatsu — 4.7.1.C CHECKING THE ELECTRICAL SYSTEM

MAINTENANCE PLAN 4.7.1.c CHECKING THE ELECTRICAL SYSTEM WARNING If the fuses are corroded, oxidized or not perfectly held in their seat, replace them only with fuses hav- ing the same capacity; before changing a fuse, make sure that the ignition key is in position « ». If there are signs of short circuit on the cables, find out the cause and repair them; always contact your Komatsu Dealer for the troubleshooting. Make sure that there are no disconnected cables or signs of short circuit in the electrical system. Make sure that all the cables are well tightened in the relevant terminals; tighten any loose cables. In particular, check: 1. Battery 2. Starter 3.

Alternator 150 4.7.1.b DRAINING THE FUEL TANK 1 WARNING • When draining the fuel tank, avoid spilling fuel, since this may cause fires. • If some fuel is accidentally spilled, clean the dirty area im- mediately, in order to prevent it from getting slippery and to avoid fires. This operation serves to let all the impurities and the condensate RWA06360 flow out of the tank; open the cock (1) at the base of the tank and wait until clean fuel flows out.

IMPORTANT • The tank must be drained before starting the engine, with temperatures exceeding 0°C (32°F); when the temperature is below 0°C (32°F), the tank must be drained at the end of 1 work or in any case with the machine at operating temper- ature, to prevent the condensate from freezing. • The condensate and the impurities that may have accu- mulated inside the tank must be eliminated before refuel- ling. RWA06370 1 WARNING • When draining the fuel tank, avoid spilling fuel, since this may cause fires. • If some fuel is accidentally spilled, clean the dirty area im- mediately, in order to prevent it from getting slippery and to avoid fires.

This operation serves to let all the impurities and the condensate flow out of the tank; open the cock (1) at the base of the tank and wait until clean fuel flows out. RWA06360 1 RWA06370 RWA06360 IMPORTANT • The tank must be drained before starting the engine, with temperatures exceeding 0°C (32°F); when the temperature is below 0°C (32°F), the tank must be drained at the end of work or in any case with the machine at operating temper- ature, to prevent the condensate from freezing. • The condensate and the impurities that may have accu- mulated inside the tank must be eliminated before refuel- ling.