MAINTENANCE PLAN 4.7.1.d CHECKING THE STEEL TRACK TENSION WARNING This operation must be carried out by two operators. One operator must be seated in the cab and oper- ate the machine according to the instructions of the operator who carries out the check and the adjust- ment. The track tension must be checked with the frame lifted from the ground; be careful not to move any control lever while the operator is carrying out the check. CHECK Stop the machine on a firm and level surface, after lowering the equipment to the ground. 1 - Raise each track by means of boom and arm. Operate the control levers slowly during this operation.
RWA06380 2 - Measure the distance between the track and the second roll- er, starting from the sprocket. If the distance is included be- tween 10 and 20 mm (0.4 to 0.8 in), the tension is normal. If the value is not included in this interval, adjust the track un- til reaching the correct value. 10-20 mm (0.4-0.8 in) RWA32890 ADJUSTMENT 151 WARNING • The grease contained in the hydraulic cylinder is under pressure. For this reason, do not loosen the greasing valve (3) giving it more than one turn; if the valve is loos- ened excessively, it may be pushed out due to the grease pressure and this is very dangerous for the operator. Do not loosen any other component in addition to the valve (3).
• If you notice excessive resistance while injecting grease, slowly move the machine forward and backward for a short distance.