Komatsu — 4.7.1.G CHANGING THE RUBBER TRACK

MAINTENANCE PLAN INSTALLING THE RUBBER TRACK 1 - Raise the undercarriage by means of boom and arm and make sure that the grease contained in the cylinder has been removed. When carrying out this operation, move the control levers slowly. RWA06380 2 - Install the rubber tracks on the sprocket, inserting the drive blocks. 1 3 - Rotate the sprocket as if in reverse (1), pushing the outer edge of the track towards the upper structure. 4 - By means of a steel tube (2), position the track and rotate the sprocket again. 5 - Make sure that the rubber track properly fits in the sprocket and the idler roller. 6 - Adjust the track tension.

For further details (See “4.7.1.f CHECKING THE RUBBER TRACK TENSION”). 2 7 - Make sure that the track tension is correct and that the track is properly inserted in the sprocket and the idler roller; place the machine on the ground. RWA06640 158