MAINTENANCE PLAN 4.7.7 MAINTENANCE EVERY 500 HOURS OF OPERATION These operations must be carried out together with those to be carried out every 100 and 250 HOURS. 4.7.7.a CHANGING THE ENGINE OIL FILTER WARNING Soon after the machine has been stopped the engine oil is very hot and may cause burns; let the en- gine cool down until it reaches a temperature of 40-45°C (104-113°F) before draining the oil. The oil that may be spilled during the change makes the ground slippery, therefore, use anti-slip shoes and immediately remove any trace of oil from the floor.
Oils, filters, the coolant and the battery are considered special waste and must be collected and dis- posed of according to the anti-pollution regulations in force. 171 This operation must be carried out every two oil changes. Proceed as follows: 1 - Drain the engine oil (See “4.7.6.e CHANGING THE ENGINE OIL”). 2 - Unscrew the used filter (1) with the special spanner provided and throw it away. 3 - Clean the contact surface between the seal and the filter sup- port. 4 - Lubricate the seal of the new filter and screw thoroughly. 5 - Give another half turn by hand. 6 - Fill the engine with new oil and complete the operations as described at point “4.7.6.e CHANGING THE ENGINE OIL”).
Start the engine, make sure that there are no leakages and that the oil pressure warning light goes out. 1 RWA06260 1 RWA06260 IMPORTANT • Do not use the spanner to lock the filter, since it may be damaged and cause oil leakages.