MAINTENANCE PLAN 4.7.7.b CHANGING THE FUEL FILTER WARNING Change the filtering element after work, when the engine has cooled down to 40-45°C (104-113°F). When these operations are carried out, fuel may be spilled; clean the dirty areas immediately, in order to prevent any risk of slipping or fire. Oils, filters, the coolant and the battery are considered special waste and must be collected and dis- posed of according to the anti-pollution regulations in force. 172 The fuel filter can be reached after opening the engine hood (See “3.5.1 ENGINE HOOD”). FUEL FILTER 1 - Close the fuel tap (1). 2 - Remove the pan (2) by means of the special spanner provid- ed and extract the filtering element.
3 - Clean the sealing surface of the cover (3) and install the new filter in the pan (2); install the O ring and smear it with some grease. 4 - Reassemble the whole unit, open the fuel tap (1) and bleed the fuel supply circuit. BLEEDING THE CIRCUIT 3 1 2 RWA06270 3 1 2 RWA06270 WARNING • The engine may start during the bleeding of the circuit; make sure that there is no one near the machine. After filling the tank, turn the ignition key to position « » and let the starter run for approximately 15÷20 seconds in order to bleed the fuel supply circuit.
RWA01970 RWA01970 IMPORTANT • If the engine starts without problems and then stops or works irregularly, check if there is air in the circuit; if so, check the tightness of the fuel filter. • After all the fuel has run out, bleed the circuit by proceed- ing as described above.