Komatsu — 4.7.8.A CHANGING THE OIL IN THE TRAVEL REDUCTION GEARS

MAINTENANCE PLAN 4.7.8 MAINTENANCE EVERY 1000 HOURS OF OPERATION These operations must be carried out together with those to be carried out every 100, 250, 500 HOURS. 4.7.8.a CHANGING THE OIL IN THE TRAVEL REDUCTION GEARS Soon after the machine has been stopped the engine oil is very hot; let the engine cool down until it reaches a temperature of 40-45°C (104-113°F) before changing the oil. WARNING Oils, filters, the coolant and the battery are considered special waste and must be collected and dis- posed of according to the anti-pollution regulations in force.

This operation must be carried out with the machine on level ground at a temperature of 40ч45°C, so that the oil is more fluid and can be drained easily together with the suspended solid par- ticles. 1 1 - Move the machine until the drain plug (2) is on the vertical ax- is in low position and the level plugs (1) are on the horizontal axis. 2 - Remove the drain plug (2) and let the used oil flow complete- ly into a container with suitable capacity. While the oil flows out, remove the plugs (1). Use a 5 mm setscrew spanner. 2 3 - After draining the oil, put back the plug (2) and pour new oil through the hole (1) until reaching the lower edge of the hole itself. Use the prescribed oil.

RWA06230 4 - Put back the plugs (1). Carry out some movements, stop the machine and check the levels again. Use only the prescribed oil (See “4.3 FUEL, COOLANT AND LUBRICANTS”). 175