MAINTENANCE PLAN 177 8 - Loosen the drain screw (8) positioned on the hydraulic pump until no air bubbles can be noticed in the oil flowing out of the screw. Use a 6 mm spanner. After bleeding the oil, tighten the screw (8). 9 - Extend the boom, arm and bucket cylinders completely as in- dicated in the figure and remove the filling cap (1). Put back the cap and pressurize the inside of the tank lower- ing the equipment to the ground. 10-Make sure that all the control levers are in neutral and let the engine idle for 2-3 minutes before operating the work equip- ment. Move each piston more than once in order to deaerate the system; check the level again and top up if necessary.
8 RWA06340 8 RWA06340 CAUTION • Do not start the engine with empty tank, since this would certainly damage the pump. RWA06730 RWA06730 IMPORTANT • The hydraulic oil used in machines provided with demoli- tion hammer deteriorates sooner than the oil used in ma- chines that carry out only normal digging operations. Change the oil according to the indications given in table beside. Replacement interval for hydraulic oil 2000 (H) 1500 interval 1000 Replacement 500 0 20 40 60 80 100 Breaker operating ratio (%) RWA07630 Replacement interval for hydraulic oil 2000 (H) 1500 interval 1000 Replacement 500 0 20 40 60 80 100 Breaker operating ratio (%) RWA07630