Komatsu — 6.2.2 USE OF THE DEMOLITION HAMMER AND RULES TO BE OBSERVED

ARRANGEMENT FOR THE INSTALLATION OF THE DEMOLITION HAMMER (BREAKER) 6.2 ARRANGEMENT FOR THE INSTALLATION OF THE DEMOLI- TION HAMMER (BREAKER) WARNING For the characteristics of the hammer, see “6.1.3 CHARACTERISTICS OF THE OPTIONAL EQUIP- MENT”. The demolition hammer is very noisy, therefore always wear headphones when using it. 6.2.1 DESCRIPTION AND CONTROL The machine can be fitted for the application of a demolition hammer; the operation of the hammer is obtained by means of an additional distributor controlled by a pedal (1) positioned on the left side.

The hammer is operated by pressing the pedal (1) with the toe, since pressurized oil is thus introduced in the delivery circuit (left side); the oil flow is interrupted and therefore the hammer is stopped by releasing the pedal (See “3.3.5 pos. 11 OPTIONAL EQUIPMENT CONTROL”). 1 RWA06400 6.2.2 USE OF THE DEMOLITION HAMMER AND RULES TO BE OBSERVED The choice of the suitable tool is a very important factor to obtain the maximum productivity from the demolition hammer. The geometry of the tool must be defined according to the nature of the material to be broken and to the type of work to be carried out.

The hammer is used to break floors, cement structures, walls, small rocky surfaces, excavations with open sec- tion, asphalt, etc. With the application of special tools it can also be used as asphalt-cutter or compactor. FOR A CORRECT USE, IT IS NECESSARY TO: 1 - Make sure that the position of the hammer with respect to the material to be broken is as perpendicular as possible and that the arm thrust is sufficient, so that all the power of the hammer can be exploited. RWA06410 191