Komatsu — 3.3.5 MACHINE CONTROLS

INSTRUMENTS AND CONTROLS 7 - ACCELERATOR LEVER This lever serves to adjust the speed and power of the engine. Idling position (1): Lever pushed completely forward. 1 Maximum speed position (2): Lever pulled completely backward. Use the accelerator lever with care, especially when the ma- chine is under strain or is working in difficult conditions. Avoid any useless acceleration, in order to reduce consumption and extend the life of either the engine and the machine. RWA07330 2 80 6 - BLADE CONTROL LEVER WARNING • Before moving the machine, make sure that the blade is completely raised. WARNING • Before moving the machine, make sure that the blade is completely raised.

This lever controls the raising and lowering of the blade accord- ing to the movements indicated. N - Neutral A - Blade lowering B - Blade raising N B RWA07320 A N B N B RWA07320 RWA07320 CAUTION • On machines with variable track gauge this lever is used also to widen or narrow the track gauge. The control is enabled by means of the push button posi- tioned on the left joystick lever. For its use, see ”3.3.3 pos. 7 VARIABLE TRACK GAUGE CONTROL PUSH BUTTON”. • Carry out the track gauge widening or narrowing opera- tions with the machine resting on firm and level ground and with the tracks raised from the ground, in order to avoid damaging the shoes and the hydraulic motors.

With pressed button, the lever controls the widening and narrow- ing of the track gauge according to the movements indicated. N - Neutral A - Track gauge widening B - Track gauge narrowing RWA28860 RWA28860