Removing and installing camshaft, exchanging camshaft bearings Removing camshaft D Drain coolant, see page 40 D Remove oilpan, see page 56 D Remove starter, see page 117 D Remove flywheel and timing case, see page 66 D Remove the rocker arms and take out the push rods, see page 79 Note: For removing the camshaft the engine must be turned by 180 _ . For this reason the engine must be placed on a dolly. Fig. 1 Turn engine upside down so that the valve tappets do not obstruct removal of camshaft. Pull out camshaft; ensure that the camshaft bear- ings do not get damaged. Check camshaft for wear and damage, if necess- ary exchanging it.
If the camshaft or the drive gear is damaged, a new entire camshaft / gear unit must be fitted. 1 Fig. 2 Push push rods out of the guide using a suitable mandrel, check them for wear, if necessary ex- changing them. Push rods can be removed only if the camshaft is removed first. 2 Exchanging camshaft bearings Fig. 3 Knock out the camshaft bearing bushes using a suitable mandrel and knock in the new bushes until flush. Ensure that the position of oil supply bore (arrow) is correct. Note: The axial camshaft stop is located behind the last camshaft bearing bush on the tim- ing case side. Owing to the helical gearing of the drive gear, the camshaft is always pulled against this stop. 3 99